日本CCS-CHN HPRS / HPRM Series参数资料
日本CCS-CHN HPRS / HPRM Series参数资料
HPRS / HPRM Series
[Not available in Japan]
"FALUX sensing"* Included in HPRS Series. enables monitoring of brightness and feedback control.
*Included in HPRS Series only.
Achieves high-uniformity over a flexible LWD range by using a unique illuminating mechanism.
特点
Built-in “FALUX” circuit to correct variations in brightness
*Included in all models.
Using the constant current circuit dependent on the input voltage, variations in the forward current of individual LEDs are corrected for uniform brightness.
Meanwhile, the temperature compensation circuit compensates for fluctuations in brightness due to increases in temperature after lighting or changes in the ambient temperature.
FALUX not included
In order to reduce LED forward voltage variations, the LEDs needed to be sorted according to their Vf measurement. Moreover, illumination efficiency dropped as the temperature increased, reducing the brightness.
FALUX included
The brightness of each LED is fixed, virtually eliminating variations in brightness following increases in temperature. Whether with continuous illumination or ON/OFF control, brightness remains fixed.
Equipped with “FALUX sensing” for monitoring brightness and temperature through sensing
*Included in HPRS Series.
LED brightness sensing is performed using multiple built-in photodiodes. This allows for accurate measurement of LED brightness not only during continuous illumination but also with short period illumination. Absolute brightness is stored in the lighting’s internal memory to allow for instrumental error adjustment.
"FALUX sensing" also makes it possible to measure both the LED brightness of lighting and the internal temperature, and then to monitor those measurements on the controller side.Based on the monitored values, feedback control can also beperformed from the OPPF or OPPD Series controller, making it possible to maintain the factory default brightness for around 40,000 hours.
Supports from low angles to high angles
Provides diffused light from the LEDs without waste using a unique illuminating mechanism. Even if the distance from the workpiece to the Light Unit is changed, there is little variation in the uniform region and it can therefore be used for a wide variety of uses.
Achieves a uniform region with a high degree of freedom
型号・产品阵容列表
| 型号名/详情 |
DXF图纸
|
宣传单页
|
使用说明书
|
STEP Drawing
|
|---|---|---|---|---|
HPRS-50RD
Outer diameter 50 mm, Inner diameter 18 mm, Height 18 mm
|
||||
HPRS-50SW
Outer diameter 50 mm, Inner diameter 18 mm, Height 18 mm
|
||||
HPRS-50BL
Outer diameter 50 mm, Inner diameter 18 mm, Height 18 mm
|
||||
HPRS-75RD
Outer diameter 91 mm, Inner diameter 41 mm, Height 26.4 mm
|
||||
HPRS-75SW
Outer diameter 91 mm, Inner diameter 41 mm, Height 26.4 mm
|
||||
HPRS-75BL
Outer diameter 91 mm, Inner diameter 41 mm, Height 26.4 mm
|
||||
HPRS-100RD
Outer diameter 116 mm, Inner diameter 66 mm, Height 26.4 mm
|
||||
HPRS-100SW
Outer diameter 116 mm, Inner diameter 66 mm, Height 26.4 mm
|
||||
HPRS-100BL
Outer diameter 116 mm, Inner diameter 66 mm, Height 26.4 mm
|
||||
HPRM-150RD
Outer diameter 166 mm, Inner diameter 116 mm, Height 26.4 mm
|
||||
HPRM-150SW
Outer diameter 166 mm, Inner diameter 116 mm, Height 26.4 mm
|
||||
HPRM-150BL
Outer diameter 166 mm, Inner diameter 116 mm, Height 26.4 mm
|
||||
HPRM-200RD
Outer diameter 216 mm, Inner diameter 166 mm, Height 26.4 mm
|
||||
HPRM-200SW
Outer diameter 216 mm, Inner diameter 166 mm, Height 26.4 mm
|
||||
HPRM-200BL
Outer diameter 216 mm, Inner diameter 166 mm, Height 26.4 mm
|
